HR Interview Interview HR Interview


In calculating the strength of a riveted joint in tearing, shearing and crushing, the


A. actual diameter of rivet is used
B. actual diameter of hole drilled for rivet is used
C. mean diameter of hole drilled and rivet is used
D. smaller of the rivet diameter and hole diameter is used

Read Solution (Total 0)

HR Interview Other Question

Two solid shafts 'A' and 'B' are made of the same material. The shaft 'A' is of 50 mm diameter and shaft 'B' is of 100 mm diameter. The strength of shaft 'B' is __________ as that of shaft A.


A. one-half
B. double
C. four times
D. eight times


Fatigue test is carried out for


A. stresses varying between two limits of equal value, but of opposite sign
B. stresses varying between two limits of unequal value, but of opposite sign
C. stresses varying between two limits of unequal value but of same sign
D. all of the above